Authors:
Serhii Nekrasov, Heba Kardoush, Suzanne Masri, S. Manivannan, Ghefar Alaa Aldeen Alrefai, Lam Chun-Kit
Addresses:
Department of Manufacturing, Engineering, Machines and Tools, Sumy State University, Sumy, Sumy Oblast, Ukraine. Department of Planning and Environment, Faculty of Architecture and Urban Planning, Cordoba Private University, Aleppo, Aleppo Governorate, Syria. Department of Material Science Engineering, Faculty of Mechanical Engineering, Aleppo University, Aleppo, Aleppo Governorate, Syria. Department of Electrical and Electronics Engineering, SRM Institute of Science and Technology, Ramapuram, Chennai, Tamil Nadu, India. Department of Informatics and Communications Engineering, Faculty of Engineering, EBLA Private University, Idlib, Idlib Governorate, Syria. Department of Manufacturing, Pearl Harbour Manufacturing, Tsuen Wan, Hong Kong.
The Soft-Switching Full-Bridge (SSFB) converter and Half-Bridge (HB) LLC resonant converter in this research constitute a hybrid DC-DC converter for on-board chargers. The hybrid architecture aims to achieve high conversion efficiency, low switching losses, voltage management, and reliable operation under various charging conditions. The secondary-side switch and diode limit circulating current and allow full soft switching of the SSFB converter's primary-side switches. The proposed design reduces circulating current and switching losses, improving efficiency and power management in high-frequency electric-vehicle charging converters. Closed-loop secondary-side switch duty cycle control modulates converter output voltage. This study explores a phase-shift-modulated, high-frequency full-bridge resonant DC-DC converter with efficient power transfer and accurate output-voltage regulation. Proportional-integral-derivative (PID) and sliding-mode closed-loop control are examined. Performance is compared using overshoot, rise time, settling time, and steady-state error. Sliding-mode controllers are more resistant to parameter changes, load disturbances, and nonlinear operating conditions than PID controllers. The small-signal model evaluates the converter's dynamic characteristics and supports closed-loop controller design. The mathematical model shows how to adjust converter variables and controller settings for rapid, reliable operation. MATLAB/Simulink simulations test the topology and control methods under varying input voltage, load, and operating conditions. Experimental results confirm the simulations and demonstrate the design's feasibility. The hybrid converter's dynamic response, output-voltage regulation, switching losses, and steady operation make it better suited for high-frequency on-board electric-vehicle charging systems.
Keywords: Half-Bridge (HB); Sliding-Mode Control; PID Controllers; Soft Switching; Output-Voltage Regulation; Resonant Converter; Closed-Loop Control; High Conversion Efficiency.
Received on: 08/10/2024, Revised on: 17/12/2024, Accepted on: 22/02/2025, Published on: 05/10/2026
DOI: 10.69888/FTSES.2026.000794
FMDB Transactions on Sustainable Energy Sequence, 2026 Vol. 4 No. 2, Pages: 68-83